Garage door won't close: sensor repair in Madison

If the door won't close from the remote and the opener light blinks, the sensors are the first place to look.

Call (475) 338-3654

In short

Blinking sensor light, door reversing, or a door that only closes while you hold the wall button: all three point to the photo-eye sensors. Clean and realign them first. If that doesn't work, call, and a technician in Madison repairs the sensors and re-tests the opener's safety system.

Ceiling opener and torsion spring over a single garage door

Doors that won't close in Madison

Madison's shoreline, from Circle Beach and the East River to Middle Beach and the Hammonasset area, is hard on sensors. Salt air corrodes the brackets and the wire ends, wind-blown sand coats the lenses, and seasonal houses that sit closed for months grow cobwebs across the beam. After a coastal flood, sensors that were under water should be replaced. Downtown, older houses have small detached garages. North Madison is different country: rugged, rocky and wooded, with steep driveways that wash grit down to the door. If a beach-house door will not close on the first weekend of the season, clean the lenses before anything else.

Why a garage door refuses to close

  • Door starts down, then goes back up. Something is blocking, or seems to be blocking, the two safety sensors near the floor.
  • Opener light blinks and the door stays open. The sensors have lost sight of each other: a bumped bracket, a dirty lens or a broken wire.
  • Door closes only if you hold the wall button. That is the opener overriding its sensors. It tells you the sensors are the problem, and it is not a way to run the door day to day.
  • Door closes, touches the floor and reopens. The travel or force setting is off, or the floor has heaved and the door thinks it hit something.

Three safe checks before you call

  1. Look at the small lights on both sensors. Each should be on and steady.
  2. Wipe both lenses with a dry cloth and make sure nothing is leaning in the doorway.
  3. Gently turn the blinking sensor until its light goes steady, then try the remote again.

If that doesn't do it, stop there. Don't tape the sensors together or bypass them.

Fixing it properly

Most of these visits are short. Sensors are realigned or replaced as a matched pair, damaged wire is rerun and secured, and the opener's travel and force are set for your door. If the opener is old enough that it has no working safety reverse at all, the technician will say so and explain the options, and nothing is replaced without your say-so.

Around Madison

  • Hammonasset area: The eastern shore near the state park, with coastal homes and salt exposure.
  • North Madison: Hilly, wooded and rural, with larger lots, long drives and colder winters.

See the full Madison service area.

Door stuck? Call before you try to force it.

Springs and cables hold a lot of tension. Don't lift the door by hand or keep pressing the opener; call and we'll book a technician.

Call (475) 338-3654
Call (475) 338-3654